Roll forming machines form long metal strips (usually from coils) into continuous, constant-section sections via successive roll stations, and differ from bending machines because they gradually form the metal as it passes through the roll lines.
Decoiler for uncoiling coils
Feeding and guiding unit
Multiple roll forming stations
Flying Cut / Shear system
Electrical/PLC control panel
Calibration and alignment system
Run-out Table
Measuring sensors
Carbon Steel (Coil)
Galvanized sheet metal
Stainless steel (as per design)
Aluminum (as per requirements)
Coated metal strips
Continuous and fast production
High consistency of the section
Suitable for Mass Production
Less waste due to continuous operation
Improved surface quality and reduced finishing
Flexibility in designing the sector according to the rolls
Reduce unit cost while increasing production
